Algo 3226 Podręcznik Użytkownika Pobierz pdf (Strona 5)

- 5 -

Quick Install & Test

The 3226 Trunk Port FXO Doorphone is pre-congured for a typical

installation. Programming is only required to change default setting or for more

advanced applications.

1. Connect the power supply to the

Power Jack of the Doorphone

Controller and plug into an

available AC outlet.

2. Flush or surface-mount the

Digital Door Station at desired

location and connect a twisted

telephone wire pair between

the “CTRL” terminals of the

Door Station and the center pair

(red and green) of the supplied

Telephone Wiring Jack. Polarity

is not important.

3. Using the short six conductor

modular cable, connect the

Telephone Wiring Jack to

the Door Station Jack of the

Doorphone Controller.

4. Using the 6 foot (1.8 m) two-wire modular cable, connect your telephone,

FXO Gateway, or analog trunk port of a traditional phone system to the

Telephone Jack of the Doorphone Controller.

5. Press the call button of the Door Station. The phone will ring and the call

button will ash. A default CLID message of “Doorphone” is sent to the

telephone.

6. Answer to communicate with the Door Station. Press the DTMF digit 6 to

activate the door control relay for three seconds if applicable.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Brak uwag

Algo 3226 Podręcznik Użytkownika Strona 5